I previously had a trracer that shot fine with both CO2 and HPA. This Tagmaster shoots OK with CO2 but very low with HPA. What should I look into to get it shooting with both? I usually use HPA but in some instances 12G CO2 is all that's available. What springs does it like?
Announcement
Collapse
No announcement yet.
Trracer Tagmaster
Collapse
X
-
Originally posted by BigRed View PostYou can use a cocker spring kit on these, just cut the valve spring to length.
Comment
-
How far off is the fps from co2 to the shp tank? It is possible that your shp is too high and you’re overpressurizing the valve. Try a regular tank and see what results you get before you rule that out. I doubt you will see the same fps as co2 but if it’s closer then you want to use that before you start swapping springs.
-
-
Originally posted by BigRed View PostThere isn't too much you gan change on these basic Nelsons. Try a lighter valve spring to let more air through. Your Tagmaster should have an adjustable bolt too. The over bored barrel will also impact your velocity, but not much to do unless you get the body rethreaded.
Comment
-
Too bad they can’t be bored, I have a couple that I would love to make more field ready for todays smaller paint.Feedback: https://www.mcarterbrown.com/forum/b...ova-s-feedback
WTB: ICD stuff, single trigger electro frames
Comment
-
Originally posted by Super Nova View PostToo bad they can’t be bored, I have a couple that I would love to make more field ready for todays smaller paint.
- Likes 1
Comment
Comment