instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

Trracer Tagmaster

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Trracer Tagmaster

    I previously had a trracer that shot fine with both CO2 and HPA. This Tagmaster shoots OK with CO2 but very low with HPA. What should I look into to get it shooting with both? I usually use HPA but in some instances 12G CO2 is all that's available. What springs does it like?

    #2
    You can use a cocker spring kit on these, just cut the valve spring to length.
    BigRed's feedback

    Comment


      #3
      Originally posted by BigRed View Post
      You can use a cocker spring kit on these, just cut the valve spring to length.
      Thanks. I'm using a SHP reg and thought it would be fine. But alas. Any other tricks for these? I'm not that familiar with Sheridan's

      Comment


      • Chappy

        Chappy

        commented
        Editing a comment
        How far off is the fps from co2 to the shp tank? It is possible that your shp is too high and you’re overpressurizing the valve. Try a regular tank and see what results you get before you rule that out. I doubt you will see the same fps as co2 but if it’s closer then you want to use that before you start swapping springs.

      #4
      There isn't too much you gan change on these basic Nelsons. Try a lighter valve spring to let more air through. Your Tagmaster should have an adjustable bolt too. The over bored barrel will also impact your velocity, but not much to do unless you get the body rethreaded.
      BigRed's feedback

      Comment


        #5
        Originally posted by BigRed View Post
        There isn't too much you gan change on these basic Nelsons. Try a lighter valve spring to let more air through. Your Tagmaster should have an adjustable bolt too. The over bored barrel will also impact your velocity, but not much to do unless you get the body rethreaded.
        Can trracer barrels be freaked?

        Comment


        • Chappy

          Chappy

          commented
          Editing a comment
          They are a bit too thin. Iirc it can be done but the result is the barrel is very thin and fragile

        • BigRed

          BigRed

          commented
          Editing a comment
          That's pretty much the case, it's pretty thin. On MCB 2.0 there was somebody who did a run of cocker threaded Trracer bodies. I can't remember who is was now.

          You could turn a barrel to Trracer threads. Then your issue may be will the pump handle fit over it?

        #6
        Too bad they can’t be bored, I have a couple that I would love to make more field ready for todays smaller paint.
        Feedback: https://www.mcarterbrown.com/forum/b...ova-s-feedback
        WTB: ICD stuff, single trigger electro frames

        Comment


          #7
          Originally posted by Super Nova View Post
          Too bad they can’t be bored, I have a couple that I would love to make more field ready for todays smaller paint.
          It's funny the way the MCB universe works, this thread leads to a happy score in the BST.
          BigRed's feedback

          Comment


          • Super Nova

            Super Nova

            commented
            Editing a comment
            You def beat me to that one lol and yes that was a score.
        Working...
        X