Inception Designs 3way timing trouble

[maggot]

Are you trying to set that Dye frame up with a 1mm trigger pull? Look at how it's half-way pulled in the resting position, and you also have a rear-travel trigger stop. Back those stops all the way out.
After doing that, adjust the timing rod until you've got it firing consistently without leaks.

[Paradigm 117]

It has enough pull to operate the factory 3way so you'd think it would work with a 3way touted as having the quickest switching and smallest required travel of any 3way lol, but you could be on to something. Just wouldn't make any sense.

[maggot]

Do they advertise it as having the smallest required travel? The ID actually requires longer, and the reason is that it uses a smaller o-ring. Less o-ring surface area means it has to travel the full ID of the barb to switch (and also vents a whole lot because of this). That whole thing aside, you don't want a pull that short anyways. Will just lead to short strokes.

[Paradigm 117]

A good point, I suppose that was more my assumption than their claim. Will look into trying this next.

[Super69ur]

Just gotta lengthen the timing rod.