Phantom wood handles

[rainman229]

Playing around with laser engraver. Decided to try and make a pump handle with it and see if could be done.

There made up of 38 layers of 1/8 plywood glued together.

Brown one is basic copy of the t-handle the ripple was hard to clean and came uneven,
So, on the whitish one I made them smooth so it could be cleaned easier.
Now working on a third one. Will be making this one a little fatter. Found a few spots that get too thin after sanding.
Will try a 4th round one to see holds up on the lathe.

[jetenginekyle]

I would be interested in buying one. Would look very nice when stained. Think you could make grip panels from the same material so it matches?

[rainman229]

Yes could be done. But if I did they would more likely be just basic cut outs, The time involved in just getting to that point would almost be in the too expensive to be worth it.

[BrickHaus]

I'd buy one. I'd also buy one of those shims you whipped up for your old kits.

[rainman229]

Those shims only work with this batch.

[BrickHaus]

I'll pm you. I got a used pump kit, and I think it's one of yours that needs a shim. But I'll confirm in pms.

[rainman229]

more pictures

[automeister]

I am interested in getting one if possible.!

[Pogi Si David]

I too would also like a kit!