How'd you wire the eyes? Specifically, which wires to what spot? I want to run a reflective eye on a project but have no idea what wires do what on an Eblade eye.
-
To be honest I haven’t been home enough recently to touch this project in a few weeks. So I can’t say 100% how I wired it is correct, but should be. I’ll check next weekend.Originally posted by Jordan View Post
I cross referenced the 2 pictures below.Comment
-
Would you be up for installing one of these boards in an Eblade for me once you get yours all ironed out? I also would love to know more about the rainmaker board in the Autococker if it’s not much trouble.Comment
-
I know this is a little old…
Roger, how’d you go about the swap on the blind Viking? Did you drill for eyes at the bottom of the breach?Comment
-
No worries. That Viking stayed blind, I didn’t do any drilling.Originally posted by CavemaN View Post
For the board swap I just soldered female JST connectors to the Morlock board and mated up the trigger, solenoid, battery, on/off switch, and rear LED.
Comment
-
Did you ever get it to successfully run an autococker? I just milled my Excalibur and will be making a single trigger eblade frame to run it because I know those work amazing for closed bolt logic… previous attempts at closed bolt operation using earlier morlocks were absolute failuresComment
Comment