instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

Board Swaps

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #16
    How'd you wire the eyes? Specifically, which wires to what spot? I want to run a reflective eye on a project but have no idea what wires do what on an Eblade eye.
    And God turned to Gabriel and said: “I shall create a land called Canada of outstanding natural beauty, with majestic mountains soaring with eagles, sparkling lakes abundant with bass and trout, forests full of elk and moose, and rivers stocked with salmon. I shall make the land rich in oil so the inhabitants prosper and call them Canadians, and they shall be praised as the friendliest of all people.”

    “But Lord,” asked Gabriel, “Is this not too generous to these Canadians?”

    And God replied, “Just wait and see the neighbors I shall inflict upon them."

    Comment

      #17
      Originally posted by Jordan View Post
      How'd you wire the eyes? Specifically, which wires to what spot? I want to run a reflective eye on a project but have no idea what wires do what on an Eblade eye.
      To be honest I haven’t been home enough recently to touch this project in a few weeks. So I can’t say 100% how I wired it is correct, but should be. I’ll check next weekend.

      I cross referenced the 2 pictures below.
      2 Photos

      Comment

        #18
        Would you be up for installing one of these boards in an Eblade for me once you get yours all ironed out? I also would love to know more about the rainmaker board in the Autococker if it’s not much trouble.

        Comment

          #19
          I know this is a little old…

          Roger, how’d you go about the swap on the blind Viking? Did you drill for eyes at the bottom of the breach?

          Comment

            #20
            Originally posted by CavemaN View Post
            I know this is a little old…

            Roger, how’d you go about the swap on the blind Viking? Did you drill for eyes at the bottom of the breach?
            No worries. That Viking stayed blind, I didn’t do any drilling.

            For the board swap I just soldered female JST connectors to the Morlock board and mated up the trigger, solenoid, battery, on/off switch, and rear LED.
            • Likes 1

            Comment

              #21
              Did you ever get it to successfully run an autococker? I just milled my Excalibur and will be making a single trigger eblade frame to run it because I know those work amazing for closed bolt logic… previous attempts at closed bolt operation using earlier morlocks were absolute failures

              Comment

                #22
                Originally posted by Roger7pball View Post
                No worries. That Viking stayed blind, I didn’t do any drilling.

                For the board swap I just soldered female JST connectors to the Morlock board and mated up the trigger, solenoid, battery, on/off switch, and rear LED.
                Awesome man, I appreciate the feedback. I’ll follow these steps and probably reach out to you for further guidance. If I go the Morlock route on my blind Viking. Thanks

                Comment

                Previous 1 2 template Next
                Working...
                X