What did you make today?

[Myrkul]

Not too fancy, but super functional, eye mount adapters that will let me use Vapor 5mm eyes on a B2k4 that normally came with 3mm eyes stock. They work perfectly and will hold up way longer then the plastic the 3mm eyes use anyway! I'm happy with them.

[Jordan]

Modded an Angel LCD double trigger to fit the single trigger frame I bought for my Matrix. Not quite as drop in as I'd hoped but I like how it turned out.

[XEMON]

Finally got around to re-programming the electronic lead screw for the lathe, and taking it for a test drive I ended up with a new barrel 😅
I might make a barrel tip for it ...

[scottieb]

Tell people it's swarovski crystal.

[Breakdown]

Finally got around to re-programming the electronic lead screw for the lathe, and taking it for a test drive I ended up with a new barrel 😅
I might make a barrel tip for it ...

Which ELS did you end up going with? I've been looking into several for my 9x30

[XEMON]

I used Clough42's kit, it saved me a lot of time getting the base started.
After a few firmware tweaks, i added some custom thread modes, a threading cycle, and a switch i can put on the ways to stop the carriage.

[Heavy_D]

Did a lot of sanding today, Plan is to next wet sand out with true oil, to fill some small pores, and harden it up a little. waiting on some brass bar stock, and tubing for a spring feed tube.

I Would love to Find a old PT Extreme Lever changer, or palmers/docs quick changer..

The fore end is staying a blank slate till I figure out what method of 12g changer i'm going to end up using, as well doing alot of brainstorming on how to fashion a lever changer/ pivot block for it, or to go the bolt action route. Open to suggestions/ opinions.

[XEMON]

I might make a barrel tip for it ...

well ... i did 😁
Final barrel: