Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The new site changes also meant cookie changes. Sorry. Unavoidable. If you're getting logged out, you need to clear your browser cache / data and cookies. Then when you log back in, you will be all set. More HERE on what's happening next.
Not too fancy, but super functional, eye mount adapters that will let me use Vapor 5mm eyes on a B2k4 that normally came with 3mm eyes stock. They work perfectly and will hold up way longer then the plastic the 3mm eyes use anyway! I'm happy with them.
Modded an Angel LCD double trigger to fit the single trigger frame I bought for my Matrix. Not quite as drop in as I'd hoped but I like how it turned out.
Finally got around to re-programming the electronic lead screw for the lathe, and taking it for a test drive I ended up with a new barrel π
I might make a barrel tip for it ...
Love my brass ... Love my SSR ... Hard choices ...
Finally got around to re-programming the electronic lead screw for the lathe, and taking it for a test drive I ended up with a new barrel π
I might make a barrel tip for it ...
Which ELS did you end up going with? I've been looking into several for my 9x30
I used Clough42's kit, it saved me a lot of time getting the base started.
After a few firmware tweaks, i added some custom thread modes, a threading cycle, and a switch i can put on the ways to stop the carriage.
Did a lot of sanding today, Plan is to next wet sand out with true oil, to fill some small pores, and harden it up a little. waiting on some brass bar stock, and tubing for a spring feed tube.
I Would love to Find a old PT Extreme Lever changer, or palmers/docs quick changer..
The fore end is staying a blank slate till I figure out what method of 12g changer i'm going to end up using, as well doing alot of brainstorming on how to fashion a lever changer/ pivot block for it, or to go the bolt action route. Open to suggestions/ opinions.
Comment