Amazon 19mm ID 22mm OD cf tube, turned down carmatech nemesis epoxied inside, and made an aluminum back for it all to slip in nicely.. the back isn’t glued into place yet, need to get it anodized first. I made three more backs for more CF sleeved barrels.
Announcement
Collapse
No announcement yet.
What did you make today?
Collapse
X
-
Carbon fiber foregrip for my AutoIon... why should Mag guys get all the cool stuff?
I need to re-spring the Stab for LP operation yet but I think I'm going to run it like this.
Last edited by Jordan; Today, 07:14 PM.
- Likes 6
Comment
-
made this for a shop. Still need to install the locking pins but it’s an adjustable gas through 12gram plug for testing a TIPX (not meant to be used during play)… spring loaded to ensure contact with the face seal and account for product tolerances (injection molded plastic isn’t particularly consistent).
Comment
-
Did some more work on mycustommongrel pump build... finished off the barrel, mounted the feedneck block, cut the feedhole.
Still need to drill/tap for a detent, create a barrel retaining setup of some kind, and verify operation. I'm hoping to have it completed for a pump day in two weeks... I should have most of the parts I need next weekend and the rest will show up from PPS eventually.
- Likes 1
Comment
Comment