Well boys here is #2
Well boys here is #2
This one is a bit beefier at the bottom so it lines up with more frame options.
Still working on getting the tool paths nailed down, but getting there quickly. I set one setting to avoid the feedneck, which then resulted in the tiny 0.005" lip on the front and back of the body.
I need to cut the undercut a bit closer, left a little extra to make sure i wasn't going to get to close. Then i need to tap the 2nd detent hole. It is already drilled and bored. Finally need to remove all the rest of the paint crap on and in the body.
A couple of semi before pics at the bottom. Entire body was covered in spray paint, primer and clear coat.
Well boys here is #2
This one is a bit beefier at the bottom so it lines up with more frame options.
Still working on getting the tool paths nailed down, but getting there quickly. I set one setting to avoid the feedneck, which then resulted in the tiny 0.005" lip on the front and back of the body.
I need to cut the undercut a bit closer, left a little extra to make sure i wasn't going to get to close. Then i need to tap the 2nd detent hole. It is already drilled and bored. Finally need to remove all the rest of the paint crap on and in the body.
A couple of semi before pics at the bottom. Entire body was covered in spray paint, primer and clear coat.
Comment