Bearded Works Shop Log

[superman]

Well boys here is #2
Well boys here is #2
This one is a bit beefier at the bottom so it lines up with more frame options.

Still working on getting the tool paths nailed down, but getting there quickly. I set one setting to avoid the feedneck, which then resulted in the tiny 0.005" lip on the front and back of the body.
I need to cut the undercut a bit closer, left a little extra to make sure i wasn't going to get to close. Then i need to tap the 2nd detent hole. It is already drilled and bored. Finally need to remove all the rest of the paint crap on and in the body.

A couple of semi before pics at the bottom. Entire body was covered in spray paint, primer and clear coat.

[P8ntballmerc@yahoo.com]

I can't message anyone yet. Can you message me? I have a few questions on an SFL Emag.

[superman]

Email sent.

[superman]

spent a little time tonight between customer projects to get this together for saturday. It's too late to run paint through it, but 280-283fps with reballs at 215psi with the ivg flush.

Shocktech Springs
BW spring guide
Phat rat
ccm hammer
shocktech bolt (not oringed)
ccm mini kit
aka sst reg
ccm frame
dual inception detents
Inception feedneck.

[superman]

ended up picking up one of the meteor pump and havent had a lot of time to mess with it. I was able to poke a few holes in the pump guide today though. Saw a 45 psi drop in operating pressure so that was cool. It is running in the 225-230 psi range now. Stock valve, hammer, valve spring, ivg and bolt. Inception lightest main spring and the modified pump guide thing.

[superman]

Feedneck mod and a 11/16 bore

[superman]

SR Autococker Minied, Feedneck modded and drilled for dual detents.
I could not find my banjo tap, so it was thread milled. I think this came out great.


Feedneck modded a 2k4 and drilled a rt pro foregrip for gas thru.

[superman]

Another feedneck mod.