Has anyone tried an SLPS kit in one of these at all? Mine is supposed to be here today and I’m going to use what I have in hand first before buying anything new.
-
-
Probably late to the party on saying this, but is it a coincidence these look an awful lot like CCM S5 bodies from eons ago?Comment
-
Mine arrived today after a daring rescue from USPS (shipped to a wrong hub locally and it stalled out in shipping). Looks to have all its parts, but I haven’t opened it up yet to make sure. A local got his in from the original order with his main spring, trigger plate and IVG missing.
these feel fantastic though! I didn’t see that they came with fittings, but some people were randomly getting them included. Did they just throw extra bits in Willy Nilly for some people in the first round?Attached FilesComment
-
-
Comment
-
-
Raw pump markers are availably on the website. Says 2 are available.
Comment
-
I forgot to post this here. I made a post on the Meteor Facebook page about my testing, and Fabrice responded with this:
Well, the video is up:
Originally posted by Terry A. DavisComment
-
Just receive the fittings and trigger plate from Meteor today.
Something to note is Meteor also included an additional hammer spring which is longer than the spring installed. From what I read on Meteor facebook page this will allow you to get to 285-295 fps with only turning in the IVG one turn (with stock internals).Comment
-
I didn’t get an extra hammer spring, but I got an extra baggie of the screws for the grips included. Apparently they were just giving the fittings to people early on as they had a few set lying around so they just tossed them into orders as they went off the workbench, per whomever I was chatting with on Facebook via PMs.
-
For those having trouble with leaking down the barrel after you have changed the 009 oring - Use a wrench and Allen key to tighten the cap very snugly - this has solved the lingering leaking for me.Comment
-
Just going to out this here so people might find it.
Interestingly my Meteor bolt has two o-rings, so maybe a change in the fly?Comment
-
-
science!
I was able to drop 40psi on the reg by removing the center section. I chopped off the front of an LP black chamber and the pump guide. I used the LP front for the frame screw and the guide with the vasa screw.
180PSI stock meteor valve, valve spring, hammer and a 2" spring. shooting 315pfs with reball.Comment
-
It has been a couple weeks, but i want to say im at 175psi shooting 285 with inception lightest spring with paint.
I plan on modding mine, but been under the weather the last week.
Since you cut yours, you should see if you can get one of the attktx spring perch. That should allow more air to flow between the chambers.
-
-
Anybody else's ASA leak? Just got around to building mine and it's leaking out the front. Assuming it's the oring between the brass internal piece but I don't have the right screwdriver to pull it out right now.Comment
-
Edit: I was thinking of the Bob long gear drive.Last edited by latches109; Yesterday, 09:44 PM. -
The pin comes out but the brass piece is threaded,I just removed it. Looks like it was crushed on one side a little which might bee my issue.
-
Comment