Has anyone tried an SLPS kit in one of these at all? Mine is supposed to be here today and I’m going to use what I have in hand first before buying anything new.
Announcement
Collapse
No announcement yet.
Meteor pump!
Collapse
X
-
Mine arrived today after a daring rescue from USPS (shipped to a wrong hub locally and it stalled out in shipping). Looks to have all its parts, but I haven’t opened it up yet to make sure. A local got his in from the original order with his main spring, trigger plate and IVG missing.
these feel fantastic though! I didn’t see that they came with fittings, but some people were randomly getting them included. Did they just throw extra bits in Willy Nilly for some people in the first round?
- Likes 2
Comment
-
Just receive the fittings and trigger plate from Meteor today.
Something to note is Meteor also included an additional hammer spring which is longer than the spring installed. From what I read on Meteor facebook page this will allow you to get to 285-295 fps with only turning in the IVG one turn (with stock internals).
- Likes 4
Comment
-
I didn’t get an extra hammer spring, but I got an extra baggie of the screws for the grips included. Apparently they were just giving the fittings to people early on as they had a few set lying around so they just tossed them into orders as they went off the workbench, per whomever I was chatting with on Facebook via PMs.
-
science!
I was able to drop 40psi on the reg by removing the center section. I chopped off the front of an LP black chamber and the pump guide. I used the LP front for the frame screw and the guide with the vasa screw.
180PSI stock meteor valve, valve spring, hammer and a 2" spring. shooting 315pfs with reball.
- Likes 6
Comment
-
superman Pre-chop lowest I could push it (reliably) was 250. The 180psi was easy to hit after removing the center. I’ll try one of Gants chambers for sure, looks great. I was able to push one of my trilogies to 130psi with a modified laz valve. I’ll swap it over to the meteor this week and see what happens.
-
Anybody else's ASA leak? Just got around to building mine and it's leaking out the front. Assuming it's the oring between the brass internal piece but I don't have the right screwdriver to pull it out right now.
Comment
-
Got mine set up. just need to tune and crono. Also, got that reg 2nd hand, any chance someone can ID it?1 Photo
- Likes 1
Comment
-
@Vegabond
They take PPS stabilizer internals if you ever need to rebuild it. Fair warning though, mine would randomly just no show and send tank pressure straight to the valve when gassing up occasionally. The solution was to unscrew my tank and screw it back in, then it would be back to working perfectly. Apparently that's a somewhat common occurrence with them...
-
Has anyone been able to sweet spot there regulator (seems to be around 325psi with stock parts) and not have this thing fart with the pump handle held forward? I've tried a few different springs and found unless I back the pressure off the sweet spot it farts. I assume it's due to having a really light valve spring. My next consideration is swapping in a lighter hammer or giving into the flatulence.
Comment
Comment