Any updates on if or when trigger plates will be shipped?
Announcement
Collapse
No announcement yet.
Meteor pump!
Collapse
X
-
Originally posted by KMDPB View Post
I'm guessing the answer is no, but if you are - how are they with co2?
Comment
-
Originally posted by RAZRBAKK View PostAnyone experimented with bolts? I don't have any Evo length, unfortunately. I'd like to upgrade as I've seen a couple people mention substantial velocity increases with just a bolt.
The bolts with a front oring shot 20-30 FPS faster than the ones without. Very little difference between them, other than the sound. The ID trident was louder than the AKA for example.
With front oring:- AKA Lightning
- ID trident
- Meteor stock
- Belsales
- Shocktech
I have a video I can upload if anyone is interested. I''ll follow up with some screenshots.Last edited by latches109; Today, 01:26 AM.
- Likes 3
Comment
-
here are the two hammers I used:- custom 20gram hammer + 2g lug
- stock 46g meteor hammer + 2g lug (kiss polish with 10k grit)
without touching the reg, and the IVG always flush with a set mark, reball with same barrel and tank. Only variables I changed was the hammer and valve.
Meteor valve, 20g hammer, 2" spring, IVG flush, 250PSI
Meteor valve, Meteor 46g hammer, 2" spring, IVG flush, 250PSI
I increased the weight of the hammer by 26g and gained ~100fps. F=MA works!
what about using a balanced valve?
Lazerous valve, 20g hammer, 2" spring, IVG flush, 250PSI
I did this test first, then swapped valves, and did the hammer test. 99FPS is a fairly large increase over the stock meteor valve with the same hammer - I want to retest or have peer review, just to make sure the valve wasn't doping.
aside: Clock 66 measures 10fps slower on average but both are consistent. Either the xradar is fast or the clock is slow.
- Likes 2
Comment
Comment